Analog-way TripliX - TRC8022 Manual do Utilizador descarregar pdf (Página 7)

TRIPLIX™ (TRC8022) Chapter 2 : TECHNICAL DESCRIPTION (continued)

PAGE 7

2-1. FRONT PANEL (continued)

LCD CONTROL

EXIT/MENU: Switches between Status and Control mode.

ENTER: Validates a selected item.

CONTROL: Allows scrolling thru the different menus.

H: Horizontal control (Image position, PIP position or LOGO position).

V: Vertical control (Image position, PIP position or LOGO position).

SWITCHER SELECT

1: Selection of the switcher # 1.

2: Selection of the switcher # 2.

3: Selection of the switcher # 3.

NOTE:

These is two ways to select many SWITCHER SELECT keys.

• Directly: Press successively the needed keys to select many switchers. To unselect a switcher, press again

the corresponding key. This is the default mode.

• With the SHIFT key: Press and hold the SHIFT key, then press all the needed SWITCHER SELECT

keys. This mode should be first activate with the LCD menu (CONSOLE > SHIFT

key mode > on).

SHIFT: Allows to select many SWITCHER SELECT keys (see note above).

TAKE: Allows to switch the pre-selected input onto the MAIN output with the selected

EFFECT.

T-BAR: Allows to manually switch the pre-selected input onto the MAIN output with the

selected EFFECT.

2-2. REAR PANEL

ON / OFF: AC Power switch (O = OFF, I = ON).

POWER INPUT: Standard IEC connector (100-250 VAC, 50-60Hz automatic).

RS-232

1: RS-232 connector (DB9 M) for connecting the switcher # 1.

RS-232

2: RS-232 connector (DB9 M) for connecting the switcher # 2.

RS-232

3: RS-232 connector (DB9 M) for connecting the switcher # 3.

UPDATE: Allows updating the TRIPLIX

™

. See Chapter 6 : UPDATING THE TRIPLIX

™

1 2 3 4 5 6 7 8 9 10 11 12 ... 52 53

Sem comentários

Analog-way TripliX - TRC8022 Manual do Utilizador Página 7