Analog-way TripliX - TRC8022 Manual do Utilizador descarregar pdf (Página 13)

TRIPLIX™ (TRC8022) Chapter 5 : LCD SCREEN DESCRIPTION (continued)

PAGE 13

5-5. LCD FUNCTIONS DESCRIPTION

NOTE:

Before entering in the LCD control mode select the switcher you want to adjust, with the (1, 2, 3) SWITCHER

SELECTION key. You may select more than one switcher to adjust 2 or 3 switcher at the same time.

1[MODE] + ENTER.

Select a switcher mode between:

• [mixer mode]: Set the device in MIXER mode.

• [matrix mode]: Set the device in MATRIX mode.

2[INPUT] + ENTER.

2-1 [input type] + ENTER.

c Select an input with  + ENTER.

d Select the input signal type with  + ENTER between:

• [SDTV Composite] • [SDTV SDI 2]

• [SDTV S.VIDEO] • [Computer SOG]

• [SDTV YUV] • [Computer HV/C]

• [SDTV RGBS TTL] • [Computer DVI]

• [SDTV RGB SOG] • [HDTV]

• [SDTV RGBS ana.] • [HDTV SDI 1]

• [SDTV SDI 1] • [HDTV SDI 2]

e Then for [SDTV Composite], and [SDTV S.VIDEO], select the video standard with  + ENTER between:

• [NTSC / PAL / SECAM]: automatic NTSC, PAL, and SECAM standard detection.

• [NTSC]: NTSC standard only. • [PAL]: PAL standard only.

• [SECAM]: SECAM standard only. • [B & W 50/60 Hz]: Black and White standard.

2-2 [used input] + ENTER.

Select an input and then select an item with  + ENTER between:

• [used]: A signal is connected to the input.

• [unused]: No signal is connected to the input. The input is unused.

2-3 [H sync load] + ENTER.

Select for each input the load of the H Sync. with  + ENTER.

2-4 [VCR mode] + ENTER.

This function allows improving the image contour of low quality VHS tapes. Select [on] with ENTER.

2-5 [synchronized] + ENTER.

This function allows defining the sources which are synchronized together (external genlock). The synchronized

sources can be seamless switched between themselves during an effect (into a PIP for example). This switching

mode is called VIS (Vertical Interval Switching).

2-6 [input status] + ENTER.

Indicates the status of the selected input.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 52 53

Sem comentários

Analog-way TripliX - TRC8022 Manual do Utilizador Página 13