
LiveCore™ Output Expander - Ref. LOE016
QUICK START GUIDE
Thank you for choosing Analog Way and the LiveCore™ Output Expander. By following these simple steps,
you will be able to set up and use your Powerful mul-screen Seamless Switcher based on Analog Way’s new
LiveCore™ plaorm within minutes. Discover the LiveCore™ Output Expander capabilies and intuive interface
while commanding top-notch presentaons and unleash your creavity for a new experience in show and event
management.
• 1 x LiveCore™ Output Expander (LOE016)
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x MCO 10 pin connector
• 1 x Web-based Remote Control Soware included and hosted on the device
• 1 x Rear rack mount kit (the parts are stowed in the packaging foam)
• 1 x Quick start guide*
• 1 x Safety instrucons datasheet
• 3 x LiveCore™ Link cable (OPT-LINK)
* The Quick start guide is also available on www.analogway.com
WHAT’S IN THE BOX
QUICK INSTALL AND SETUP
The LiveCore™ Output Expander uses standard
ethernet LAN networking. To connect the LiveCore™
Output Expander, you rst need to connect it to
the same network than your SmartMatriX Ultra or
Ascender 16 and your computer. To be sure it is on the
same network than your computer, open an internet
browser which supports Flash® player.
Into this internet browser, please enter the IP address
of the LiveCore™ Output Expander displayed on the
front panel screen.
The connecon should start.
Oen, computers are set to DHCP client (automac
IP detecon) mode. You may need to change the
IP address conguraon on your computer before
you can connect. These sengs are found in the
properes for your LAN network adaptor, and vary by
operang system.
The default IP address on the LiveCore™ Output
Expander is 192.168.2.140 with a netmask of
255.255.255.0. Therefore, you can assign your
computer a stac IP address of 192.168.2.100 and
a netmask of 255.255.255.0 and should be able to
connect.
If the connecon is not starng, please see:
• Be sure the computer IP address is on the same
network and subnet as the LiveCore™ Output
Expander.
• Be sure that no two devices have the same IP
address (prevent IP conicts)
• Check your network cable. You will need a crossover
ethernet cable if you are connecng directly from
the LiveCore™ Output Expander to the computer.
If a hub or switch is involved, use straight ethernet
cables.
• For more informaon, please see the user manual
or contact your local technical support.
Once you have successfully connected, the ash
app will automacally download and launch in your
browser. When the two icons in the boom right
corner of the screen turn green, the Web RCS is ready
to use. If you are having trouble syncronizing, try
clearing the cache and refreshing the page (ctrl+F5 in
most browsers):
- LOE016: will turn green when connected
- will turn green when the Web RCS has
nished syncronizing.
CAUTION!
Mounng using only the front
rack ears is sucient for xed
installaons. Addional support,
such as the rear rack support or
slide rails, is required for mobile
applicaons, and recommended
for all.
Comentários a estes Manuais