Analog-way Di-VentiX - DVX8022 Manual do Utilizador descarregar pdf (Página 8)

Chapter 1 : INTRODUCTION (continued) Di-VentiX™

PAGE 8

1-3. REFERENCES

MODELS &

OPTIONS

DESIGNATIONS

DVX8022 Di-VentiX.

OPT-iX-A Optional AUDIO input/output.

CBD-UP CROSS BLENDER

™

. Optional version for "Edge blending" application.

1-4. OPTIONAL ACCESSORIES

REFERENCES DESIGNATIONS

RK8022 Remote keypad.

RK8022-T Remote keypad with T-BAR.

TRC8022 Remote console. Allows to control up to 3 iX Range devices.

SWM-OE Remote control Software. Allows to control up to 16 to iX Range devices.

1-5. Di-VentiX INSTALLATION

IMPORTANT: Please read all of the safety instructions (pages 4 to 6) before starting.

• Table top mounting:

The device can be used directly on a table: the unit is equipped with 4 plastic feet.

• Rack mounting:

The device is compatible with a 19” enclosure. Please follow the instructions below to install the

device in a 19” rack.

 Place the device in your rack.

NOTE:

Your rack must be equipped with some braces.

 Attach the device to the rack by using 4 screws in the front panel holes (screws are not

included).

 Connect all of the cables of the device and attach them to the rack with some tie wraps.

Figure 1

IMPORTANT: - The openings in the side and in the rear panel are for cooling. Do not cover these openings.

- Be sure that no weight in excess of 2 kg (4.4 Lbs.) is added onto the Di-VentiX.

- The maximum ambient operating temperature must not exceed 40 °C (104 °F).

- The rack and all mounted equipment in it must be reliably grounded to national and local

electrical codes.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 142 143

Sem comentários

Analog-way Di-VentiX - DVX8022 Manual do Utilizador Página 8