Analog-way Smart Fade - SMF251A Manual do Utilizador descarregar pdf (Página 27)

SMART FADE™ Chapter 9 : CONTROL SOFTWARE

PAGE 27

9-1. CONNECTION (continued)

• PIN-OUT:

PIN # FUNCTIONS

2 TRANSMIT DATA (Tx)

3 RECEIVE DATA (Rx)

5 GROUND (Gnd)

8 +12 Vdc (power of the RK251)

DB 9 female

(Rear panel of the SMART FADE

™

)

• SPEED TRANSMISSION: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

9-2. "SMART FADE

™

REMOTE CONTROL" SOFTWARE

Your SMART FADE

™

is shipped with a WINDOWS 95/98/2000/Me/XP compatible "SMART FADE

™

REMOTE

CONTROL" software (3.5" disk). This software allows you to control and make adjustments by a simple mouse click

(output format, image adjustments, etc...).

• SOFTWARE INSTALLATION:

c Turn your computer ON and wait for WINDOWS to completely start.

d Insert the disk into the floppy drive.

e In the WINDOWS START menu, click on RUN.

f Choose the disk drive and click on setup.exe (ex : A:\setup.exe if disk 3.5" is drive A).

g Follow the WINDOWS installation instructions. WINDOWS will create a file C:\Programfiles\ANALOGWAY\

SMART FADE remote control.

• STARTING UP:

c Connect the RS-232 cables between the control device and the SMART FADE

™

as indicated in section 9-1.

d Then only power ON all of the devices.

e Click on the program files SMF251 in Start-program-ANALOGWAY-SMART FADE to run the software.

f Click on Control menu and select the Serial port.

The SMART FADE

™

is now connected to the computer (if not, verify the DB9 serial connection and the

selected serial port).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 80 81

Sem comentários

Analog-way Smart Fade - SMF251A Manual do Utilizador Página 27